windshield wipers HONDA CLARITY FUEL CELL 2020 Owner's Manual (in English)

Page 12 of 551

Visual Index
10
Quick Reference Guide❚Maintenance Under the Hood (P 457)
❚Windshield Wipers (P 162, 465)
❚Door Lock/Unlock Control (P 135)
❚Power Door Mirrors (P 171)
❚Headlights (P 158, 463)
❚Front Side Marker Lights (P 158, 463)
❚Front Turn Signal Lights (P 157, 463)
❚How to Refuel (P 446)
❚High-Mount Brake Light (P 464)
❚Emergency Trunk Release Lever (P 148)
❚Opening/Closing the Trunk (P 146)
❚Brake Lights (P 464)
❚Rear Turn Signal Lights (P 464)
❚Back-Up Lights (P 464)
❚Taillights (P 464)
❚Trunk Release Button (P 147)
❚Rear License Plate Light (P 464)
❚Multi-View Rear Camera (P 443)
❚Parking/Daytime Running Lights (P 158, 161, 463)
❚Tires (P 468, 490)
❚Tail/Rear Side Marker Lights (P 464)
20 CLARITY FCV CSS-31TRT6300.book 10 ページ 2019年9月10日 火曜日 午前11時3分

Page 30 of 551

28
Quick Reference Guide
Wipers and Washers
(P 162)AUTO should always be turned OFF before
the following situations in order to prevent
severe damage to the wiper system:
●Cleaning the windshield●Driving through a car wash●No rain present
Wiper/Washer Control Lever
Adjustment Ring
(-: Low Sensitivity
(+: High Sensitivity MIST
OFF
AUTO
: Wiper speed varies
automatically
LO: Low speed wipe
HI: High speed wipe
Pull toward
you to spray
washer fluid.
Steering Wheel (P 169)
●To adjust, push the adjustment lever
down, adjust to the desired position, then
lock the lever back in place.
Unlocking the Front
Doors from the Inside
(P 143)
●Pull either front door inner handle to
unlock and open it in one motion.
●Unlocking and opening the driver’s door
from the inner handle unlocks all the
other doors.
Trunk (P 146)
●To unlock and open the trunk:
•Press the trunk opener on the driver’s
door.
• Press the trunk release button on the
smart entry remote.
• Press the trunk release button on the
trunk lid.
Trunk Opener
20 CLARITY FCV CSS-31TRT6300.book 28 ページ 2019年9月10日 火曜日 午前11時 3分

Page 164 of 551

162
uuOperating the Switches Around the Steering Wheel uWipers and Washers
Controls
Wipers and Washers
The windshield wipers and washers can be
used when the power mode is in ON.
■MIST
The wipers run at high speed until you release
the lever.
■Wiper switch (OFF, AUTO, LO, HI)
Move the lever up or down to change the
wiper settings.
■Washer
Sprays while you pull the lever toward you.
When you release the lever for more than one
second, the spray stops, the wipers sweep two
or three more times to clear the windshield,
then stop.
■Windshield Wipers/Washers1 Wipers and Washers
NOTICE
Do not use the wipers when the windshield is dry.
The windshield will get sc ratched, or the rubber
blades will get damaged.
Turn the washers off if no washer fluid comes out.
The pump may get damaged.
When the wiper motor is kept running under heavy
load for extended periods of time, this protection
feature is activated, and the wiper speed may
decrease or motor operat ion may stop temporarily.
This function will be canceled within a few minutes
once the load has been reduced; the wiper operation
returns to normal.
NOTICE
In cold weather, the blades may freeze to the
windshield.
Operating the wipers in th is condition may damage
the wipers. Use the defroster to warm the
windshield, then turn the wipers on.
If the wipers st op operating due to an obstacle such
as the build-up of snow, pa rk the vehicle in a safe
place.
Rotate the wipe r switch to OFF, and set the power
mode to ACCESSORY or VEHICLE OFF (LOCK), then
remove the obstacle.
MIST
OFF
LO: Low speed wipe
HI : High speed wipe Pull to
use
washer.
AUTO
20 CLARITY FCV CSS-31TRT6300.book 162 ページ 2019年9月10日 火曜日 午前11 時3分

Page 165 of 551

163
uuOperating the Switches Around the Steering Wheel uWipers and Washers
Controls
When you push the lever down to AUTO, the
windshield wipers sweep once, and go into
the automatic mode.
The wipers operate intermittently, at low
speed, or at high speed and stops in
accordance with the amount of rainfall the
rainfall sensor detects.
■AUTO sensitivity adjustment
When the wiper function is set to AUTO, you
can adjust the sensitivity of the rainfall sensor
(using the adjustment ring) so that wipers will
operate in accordance with your preference.
Sensor sensitivity
■Automatic Intermittent Wipers1 Wipers and Washers
The washer jets are in the location shown below.
Washer Jets
1Automatic Intermittent Wipers
The rainfall sensor is in the location shown below.
NOTICE
AUTO should always be turned OFF before the
following situations in order to prevent severe
damage to the wiper system:
•Cleaning the windshield
•Driving through a car wash
•No rain present
Rainfall Sensor
Adjustment Ring
Low sensitivity
High sensitivity
20 CLARITY FCV CSS-31TRT6300.book 163 ページ 2019年9月10日 火曜日 午前11 時3分

Page 467 of 551

465Continued
Maintenance
Checking and Maintaining Wiper Blades
Checking Wiper Blades
If the wiper blade rubber has deteriorated, it will leave streaks and the hard surfaces
of the blade may scratch the window glass.
Changing the Wiper Blade Rubber
1. Set the power mode to VEHICLE OFF
(LOCK).
2. While holding the wiper switch in the
MIST position, set the power mode to ON,
then to VEHICLE OFF (LOCK).
u Both wiper arms are set to the
maintenance position as shown in the
image.
3. Lift both wiper arms.
1Changing the Wiper Blade Rubber
NOTICE
Avoid dropping the wiper arm onto the windshield, it
may damage the wiper arm and/or the windshield.
When you raise a wiper arm, you may inadvertently
alter the position of the arm by applying undue force.
If you notice that an arm is not in its proper return
position, active the wipers once and they will
automatically reset. 2 Wipers and Washers P. 162
20 CLARITY FCV CSS-31TRT6300.book 465 ページ 2019年9月10日 火曜日 午前11 時3分

Page 485 of 551

483
uuCleaning uExterior Care
Continued
Maintenance
Exterior Care
Dust off the vehicle body after you drive.
Regularly inspect your vehi cle for scratches on painted surfaces. A scratch on a
painted surface can result in body rust. If you find a scratch, promptly repair it.
Wash the vehicle regularly. Wash more frequently when driving in the following
conditions:
• If driving on roads with road salt.
• If driving in coastal areas.
• If tar, soot, bird droppings, insects, or tree sap are stuck to painted surfaces.
• Make sure to follow the instructions indicated on the automated car wash.
• Fold in the door mirrors.
• For models equipped with automatic inte rmittent wipers, turn the wipers off.
■Washing the Vehicle
■Using an Automated Car Wash
1Washing the Vehicle
Do not spray water into the air intake vents. It can
cause a malfunction.
If you need to lift the wiper arms away from the
windshield, first set the wiper arms to the
maintenance position. 2 Changing the Wiper Blade Rubber P. 465
Air Intake Vents
1Using an Automated Car Wash
When using an automated car wash that pulls the
vehicle through with a convey or, make sure vehicle is
in car wash mode. 2 If you want to keep the transmission in
(N
position [car wash mode] P. 379
20 CLARITY FCV CSS-31TRT6300.book 483 ページ 2019年9月10日 火曜日 午前11 時3分

Page 549 of 551

547
Index
Vehicle Monitoring System......................... 2
Vehicle Speed ........................................... 129
Vehicle Stability Assist
TM (VSA ®).............. 413
Off Button .............................................. 414
Off Indicator ..................................... 93, 414
System Indicator ............................... 93, 413
Voice Control Operation ......................... 232
Audio Commands ................................... 234
Climate Control Commands.................... 235
General Commands ................................ 235
Music Search Commands ........................ 235
On Screen Commands ............................ 235
Phone Commands .................................. 234
Useful Commands .................................. 234
Voice Portal Screen ................................. 233
Voice Recognition ................................... 232
VSA ® (Vehicle Stability Assist
TM).............. 413
W
Wallpaper ................................................. 216
Warning and Info rmation Messages ...... 102
Warning Indicator On/Blinking ............... 513
Warning Labels .......................................... 83
Warranties (Warranty Manual provided separately) .............................................. 535
Watts ........................................................ 530
Wear Indicators (Tire) .............................. 473
Wi-Fi Connection ..................................... 267
Window Washers ..................................... 162
Adding/Refilling Fluid .............................. 462 Switch ..................................................... 162
Windows (Opening and Closing) ............. 152
Windshield Cleaning .......................................... 481, 484
Defrosting/Defogging .............................. 192
Washer Fluid ........................................... 462
Wiper Blades ........................................... 465
Wipers and Washers ................................ 162
Winter Tires Snow Tires ............................................... 476
Tire Chains .............................................. 476
Wipers and Washers ................................. 162
Checking and Replacing Wiper Blades ..... 465
WMA ......................................................... 257
Worn Tires ................................................. 468
20 CLARITY FCV CSS-31TRT6300.book 547 ページ 2019年9月10日 火曜日 午前11 時3分